![]() In the middle, with stroke visible but no fill. Here's our starting point: the square with the star punched out, on the left. If you'd like to use the "hatch" method for geometries that fail, there are a few potential workarounds- ways that you can simplify the geometry in generally unobtrusive ways, to fill the region that you want to. Workarounds for hollow geometry hatch fills Beyond all that, it's also a "live path effect," which means that it will automatically reflow as you change the shape of the filled region, and you can even remove the hatch at any time to restore your original object. It produces excellent results that plot smoothly and efficiently, with preset deceleration at each switchback and an absolute bare minimum of pen lifts. While this hatch method is slightly complicated and does not work in every situation, it is without doubt the best method in any situation where it can be used. (It treats the inner cutout path as a separate path to be filled with hatching.) The set of four shapes on the right have the same hatch applied, but we've also pasted a copy of the original outline shapes on top, to give more definition than you get from the fill alone. As you can see, it works well on three of the four shapes but again it does not work on "hollow" areas. In the middle set of four shapes, we've applied the hatch procedure as outlined above. The four original (filled) shapes are on the left: A star, a square, a square with a star punched out- essentially a hollow, ring-shaped fill region - and a smaller square with a star punched out (a set of multiple disjoint regions). This "live path effect" hatching method can handle paths that consist of multiple disjoint regions, for example, a set of stars or non-intersecting circles, but it does not work with "hollow" regions, for example a ring or washer (2D torus) shape. You may also need to use the Fill & Stroke panel to set the stroke to be a visible pen and the fill to "none." A separate tutorial on using this method (skipping the extension) can be found here.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |